Don's Appliance Repair

07/13/2026

This beverage refrigerator had a lot of condensation building up inside.

Problems like this are often caused by a door gasket that isn't sealing properly, allowing warm air into the refrigerator. In this case, the door gasket was severely damaged and needed to be replaced.

We installed a new gasket, and it it sealing properly again.

07/01/2026

🇨🇦 Happy Canada Day from all of us at Don's Appliance Repair! 🇨🇦

06/24/2026

This washer stopped draining water.

When we took it apart, we found the drain pump had stopped working. Sometimes the problem is just a clogged filter, but that wasn't the case here.

We replaced the drain pump, tested the washer, and confirmed it was draining properly again.

10/10/2025

This Whirlpool oven showed an error code because the cooling fan stopped working. The fan keeps the oven running within safe limits. We replaced the fan, cleared the code, and the oven is back in working order.

09/24/2025

This Bosch dishwasher wasn’t cleaning properly because the soap dispenser stopped opening during the wash cycle. Without detergent, dishes stay dirty no matter how hot the water gets. We replaced the dispenser and the dishwasher is working properly again.

09/18/2025

https://youtube.com/shorts/pWjIhh8CouA?feature=share

In this video, we changed the door hinges on a Sub-Zero refrigerator in Victoria. The worn hinges kept the door from closing tight, which caused warm air to ...

08/21/2025

There was a lot of lint build up in this dryer that wasn't drying clothes. This can block airflow, it's a serious fire hazard. Lint is highly flammable, and when it collects around the heating element, it can ignite. A good cleaning keeps your dryer running safely and efficiently. It is a good idea to check this annually.

06/17/2025

This oven had a failed control board. When this happens, any number of different features in the oven can stop working. This board is about to come out so we can install the new one. After we replaced it, everything was tested and working normally again.

05/13/2025

This is a failed bake element next to the new one we installed in a BlueStar oven. When these elements fail, it can create quite the spark show, but there is nothing to be concerned about. You just need a new element.

03/09/2025

Dryer not heating? Here's a look inside one we just fixed. The heating element had failed in this Speed Queen dryer. We swapped it with a new one and got the dryer running like it should again. If your dryer's tumbling but not drying, this could be the culprit.

Need help with yours? Give us a shout.
www.donsappliancerepair.ca