ICON Fire & Life Safety

Name: ICON Fire & Life Safety
Address: Taylor, Taylor, TX, 78669, US
Telephone: +15127782266

Home
United States
Taylor, TX
ICON Fire & Life Safety

Call Website Contact the business

ICON Fire & Life Safety is dedicated to providing high-quality Fire Alarm, Fire Sprinkler, and ERCES equipment for commercial properties.

At Icon Fire & Life Safety, we are dedicated to providing high-quality Fire Alarm and ERCES equipment for commercial properties. We have been in the industry for over 10 years and have a team of experts who are committed to ensuring the safety of our customers.

09/19/2026

Arrr…
Remember this, matey:
fire safety be cheaper than rebuildin’ the ship.— ICON Fire & Life Safety

09/04/2026

Today we celebrate the work that keeps everything running.

Happy Labor Day from ICON Fire & Life Safety.

09/03/2026

Diesel vs electric fire pumps — the real trade-offs

Choosing between a diesel and electric fire pump? Here are the real trade-offs:

ELECTRIC:
• Lower installation cost (no fuel tank, no exhaust, no ventilation)
• Lower maintenance (no engine oil, filters, batteries)
• Relies on building power — if power fails, pump fails (unless you have a generator with adequate capacity)
• Simpler weekly test (10 minutes, no fuel consumption)

DIESEL:
• Higher installation cost (fuel tank, exhaust, ventilation, room separation)
• Higher maintenance (oil changes, filter changes, battery replacement, fuel polishing)
• Independent of building power — runs even in a total power outage
• Required by many AHJs for high-rise and critical facilities
• 30-minute weekly test

Rule of thumb: if losing building power is a realistic scenario and your facility is critical (hospital, high-rise, detention), go diesel. Otherwise, electric with generator backup is usually sufficient.

ICON installs, tests, and services both types.

09/01/2026

RPZ vs double check — which backflow preventer does your fire system need?

Not all backflow preventers are created equal. Here's the difference:

RPZ (Reduced Pressure Zone): Has two check valves plus a relief valve that dumps water if the pressure drops. If the device fails, it fails safe — water is discharged rather than flowing backward. This is the highest level of protection.

Double Check (DCVA): Two check valves in series. No relief valve. If a check valve fails, there's no visible signal — backflow could occur silently.

Most Texas water utilities now require RPZ for fire sprinkler connections. Some still accept double check for certain building types. Check with your local water department or ask us — we know the requirements for every utility in Central Texas.

ICON installs, tests, and repairs both types. If you're upgrading from double check to RPZ, we handle the swap and the paperwork.

08/27/2026

Wet chemical vs dry chemical — kitchen hood suppression explained

Kitchen hood fire suppression systems use wet chemical agents (typically potassium acetate based). Here's why wet chemical is the standard for commercial kitchens:

Dry chemical (ABC powder) knocks down the flame but doesn't cool the grease. Re-flash is almost certain.

Wet chemical does three things:
1. Knock down the flame (rapid smothering)
2. Cool the grease below its auto-ignition temperature (prevents re-flash)
3. Form a foam blanket over the grease surface (starves oxygen)

This is why NFPA 17A specifically requires wet chemical for restaurant hood systems. If a vendor offers you a dry chemical system for a commercial kitchen, they're not following the standard.

ICON installs and services UL 300 wet chemical kitchen hood systems. All our systems meet current UL 300 and NFPA 17A requirements.

08/25/2026

ERCES signal testing — the grid test explained

Before installing an ERCES/BDA system, you need a signal test. Here's how it works:

We divide your building into at least 20 grid squares. In each square, we measure the inbound (downlink) and outbound (uplink) radio signal strength from the local public safety radio system.

If any grid square fails (signal below -95 dBm), that area needs antenna coverage. The test results drive the system design — how many antennas, where to place them, how much amplifier gain is needed.

After installation, we re-test every grid square to prove coverage meets the AHJ's minimum. The report goes to the fire marshal for sign-off.

ICON performs grid testing with calibrated equipment and delivers AHJ-ready reports. If your building hasn't been tested yet, schedule it before your next fire marshal inspection.

08/20/2026

The 5-year sprinkler internal inspection — are you overdue?

NFPA 25 requires an internal inspection of sprinkler piping every 5 years. This means opening a representative sample of branch lines and mains to check for corrosion, debris, scale, and obstructions.

If you've never had this done, you're not alone — most building owners don't know it's required. But ignoring it means:

• Corroded pipes that restrict water flow
• Debris that can plug a sprinkler head when it needs to operate
• Microbiologically Influenced Corrosion (MIC) that eats pipe from the inside

ICON performs 5-year internal inspections with a full report and photos. If we find corrosion, we'll show you exactly where and recommend repair or replacement before the system fails when you need it most.

08/18/2026

Addressable vs conventional fire alarm systems — which does your building need?

If you're renovating or building new, this is one of the first fire protection decisions you'll make.

Conventional systems zone devices by wire — when an alarm triggers, you know which zone, but not which specific device. Good for small buildings with simple layouts.

Addressable systems give every device a unique ID. The panel tells you exactly which smoke detector, pull station, or heat detector activated — down to the room. Faster response, easier troubleshooting, and much lower false-alarm risk.

For multi-story office, retail, or residential: addressable is almost always the right call. The cost difference has shrunk dramatically in the last 5 years.

ICON designs and installs both. We'll assess your building and recommend what fits — not what's most profitable for us.

08/13/2026

Fire pump weekly churn test — why you run it and what to look for

If your building has a fire pump, you're required to run a weekly churn test (no-flow test). NFPA 25 says 10 minutes for electric pumps, 30 minutes for diesel.

The point isn't just to 'run the pump.' You're checking:
• Pump starts automatically on pressure drop
• Pump runs without abnormal noise or vibration
• Packing box leakage is within limits (10-60 drops/minute is normal)
• Bearing temperatures are normal
• Pressure gauge readings are consistent with baseline
• For diesel: oil pressure, water temp, battery charge

We see too many building owners skip this or do it wrong. The weekly churn is your early warning system — if the pump won't start when you test it, it won't start in a fire.

ICON provides weekly, monthly, and annual fire pump testing per NFPA 25.

08/11/2026

🚨 ICON Fire & Life Safety is HIRING! 🚨

We’re growing and have an immediate need for a few great people to join our team:

🔥 RME-I
🔥 Licensed Kitchen Hood Technician
📡 ERCES Technician Trainee — no ERCES experience required. We’re looking for a sharp, motivated person who wants to learn, work hard, and build a career in the ERCES world.

If you’re experienced, motivated, or know someone who would be a great fit, send us a message!

Come grow with ICON Fire & Life Safety.

Address

Taylor
Taylor, TX
78669

Telephone

+15127782266

Website

http://www.iconfls.com/

Alerts

Be the first to know and let us send you an email when ICON Fire & Life Safety posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to ICON Fire & Life Safety:

Want your business to be the top-listed business in Taylor?