Three metal fabrication

Call Directions Contact the business

Three metal fabrication Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from Three metal fabrication, Business service, Camira, Ipswich.

Trade qualified metal fabricator with over 15 years experience
Aluminium
Stainless steel
Car Restoration
We cover all types of fabrication no job to big or small

Rear bumper and beaver infill panel modified to suit the extra width across the rear end.
18/09/2026

Rear bumper and beaver infill panel modified to suit the extra width across the rear end.

Finishing off the rear fire wall in Bob’s fj. and added some extra length to the rear bumper bar to accommodate the extr...
18/09/2026

Finishing off the rear fire wall in Bob’s fj. and added some extra length to the rear bumper bar to accommodate the extra width in the guards

Tyler’s Hilux was in for a tidy up on the gear box tunnel, front panard mount was never going to work so out with old in...
25/08/2026

Tyler’s Hilux was in for a tidy up on the gear box tunnel, front panard mount was never going to work so out with old in with the new and mount in the rear sway bar.

Mick’s toner come in for a bit of a spruce up with some panels and custom tray end result come up a treat.
23/08/2026

Mick’s toner come in for a bit of a spruce up with some panels and custom tray end result come up a treat.

Was given the task to knock some of the ugly off this one. 80 series chassis swapped with 79 tub.
16/07/2026

Was given the task to knock some of the ugly off this one. 80 series chassis swapped with 79 tub.

Eh was in for a few things for a tidy up. Fresh set of tubs and open the tunnel up to house a bigger box and cross membe...
26/06/2026

Eh was in for a few things for a tidy up. Fresh set of tubs and open the tunnel up to house a bigger box and cross member.

Simple and functional fit out with some under floor storage for Brenton’s setup.
01/06/2026

Simple and functional fit out with some under floor storage for Brenton’s setup.

This one come in looking a bit second hand, scope of the work was to get the canopy back to square as possible and tidy ...
23/05/2026

This one come in looking a bit second hand, scope of the work was to get the canopy back to square as possible and tidy up some panels and make a new door.

Bit of a tight one with the rack conversion. routed the pipes to make it work
12/05/2026

Bit of a tight one with the rack conversion. routed the pipes to make it work

Few little rust sections on Shanon’s factory turbo vl before heading off for paint and panel.
27/04/2026

Few little rust sections on Shanon’s factory turbo vl before heading off for paint and panel.

Address

Camira
Ipswich, QLD
4300

Telephone

+61488108846

Website

Alerts

Be the first to know and let us send you an email when Three metal fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Three metal fabrication:

Shortcuts

Share

Category