Saturn Audio

16/04/2018

Channel strip production run has begun...

22/01/2018

A repurposed signal gen converted to a single tube preamp, for guitar use. When at full gain, some sweet distortion just about starts to show up. Put before a valve amp this will make her purr. €150

12/12/2017

Wooly Mammoth Clone. Isolated the circuitboard, resoldered pots, new transistors and tightened all the jacks and pots.

22/10/2017

Passive Pultec-style EQ coming up!

09/10/2017

The OverDose OD pedal. The name says it all.

24/09/2017

€320
Based on the original, legendary Altec 1566. Though it has some mods: I've omitted the input transformer to save costs, as it's only needed if you're using it as a mic pre. In that case, an input transformer should be added. The high-bleed capacitor on the input was also left out. before the first volume pot an inductor based hi-boost was installed (switchable on front panel). Output impedance is about 305 ohms. Balanced out (line) and amp out. About 20dB's of gain!

10/09/2017

04/09/2017

Upcoming project

18/05/2017

Acoustical absorption panels, 100mm thick. Effective from 300Hz up (against wall). Both mobile as fixed versions available.

18/05/2017

The mighty Mach 1. Loosely based on the "Marshall Plexi 1959 " . She produces about 36 watts of screaming volume, so keep ear protection close by! For your playing pleasure there are TWO (yes, TWO) channels, high gain and clean. Although clean can be a relative term...
The amp features a preamp out jack, which also doubles as a external preamp input. 6L6 Sovtek power tubes give this beast it's volume.