Sooner 3D Printing and Engineering

Sooner 3D Printing and Engineering Welcome to Sooner 3D Printing and Engineering! Providing print services, design, supplies, and training to Oklahoma City Metro

Solving short people problems with 3D printing.
09/21/2021

Solving short people problems with 3D printing.

Bahtinov mask for a 15” telescope
06/13/2021

Bahtinov mask for a 15” telescope

Halloween 🎃 👻 is such a great time for 3D Printing!!!! It’s the Poltergust from Luigi’s Mansion 3.
10/09/2020

Halloween 🎃 👻 is such a great time for 3D Printing!!!! It’s the Poltergust from Luigi’s Mansion 3.

09/24/2020

The new Creality CR-6SE. Probably the quietest printer. Going to put it through it’s paces and hopefully we won’t see any of the issues that have been report. Hopefully Creality figure them all out and this printer will be a great addition to anyone’s tools.

First print in the enclosure. Pencil holder for the kid’s desk.
08/10/2020

First print in the enclosure. Pencil holder for the kid’s desk.

Structurally done! Added gas struts to dry box door. Need to cut some PTFE tubes and it’s ready for its tenants.
05/07/2020

Structurally done! Added gas struts to dry box door. Need to cut some PTFE tubes and it’s ready for its tenants.

Twin Prusa Enclosure almost done. Just need to get a 12V power supply for the fans wired up. Print the rest of the auto ...
05/04/2020

Twin Prusa Enclosure almost done. Just need to get a 12V power supply for the fans wired up. Print the rest of the auto rewinding spools and run the PTFE tubing from the dry box to below.

It took 2 days 6 hours but it finally finished. It was difficult getting it off the build plate.
04/10/2020

It took 2 days 6 hours but it finally finished. It was difficult getting it off the build plate.

Custom paver-stone molds for a customer.
04/08/2020

Custom paver-stone molds for a customer.

04/08/2020

Very large prints can be a pain. CR-10S5 print bed maxed out. Had some adhesion and warping issues. But finally after 5 days of failures it’s looking successful.

Prusa MK3S twin enclosure coming along. All I have left is to finish the dry box and all the doors. Room for 2 Prusa MK3...
03/28/2020

Prusa MK3S twin enclosure coming along. All I have left is to finish the dry box and all the doors. Room for 2 Prusa MK3S with MMU2S. Fed by 10 auto rewind spools from above through 10 PC4-M10 fittings and PTFE Tube. LED lighting and HEPA Filter.

Address

Edmond, OK
73013

Opening Hours

Monday 9am - 5pm
Tuesday 9am - 5pm
Wednesday 9am - 5pm
Thursday 9am - 5pm
Friday 9am - 5pm
Saturday 9am - 5pm

Website

Alerts

Be the first to know and let us send you an email when Sooner 3D Printing and Engineering posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category