16/09/2025
GET IT DONE TIMORROW SAVE $100 OFF MY PRICE
What's an appliance tune up? I don't know, but here's what I will check for you. This usually cost about $500-$700 ( ballpark) I will do it for $350. Dust, debris, and moisture is The #1 reason for appliance failure
617-953-7783
Stove
Inspect electrical system for proper
ground and secure connections.
Visually check readily accessible wiring insulation for cracks or peeling.
Heat check oven controls for accurate temperatures.
Check oven door and door gasket for proper alignment. Make sure gasket is clean and soft.
Level range as needed and make sure the anti-tip device is installed.
Check and adjust clock/timer as needed.
Test self-cleaning lock mechanism.
Check electronic controls to ensure proper functions.
Check surface/oven burners/ elements.
Test gas line and connections for leaks.
Check warming drawer operation and alignment.
REFRIGERATOR SERVICE
Clean condenser.
Check and properly adjust thermostat, temperature controls, and air dampers.
Check the automatic defrost cycle.
Check door seals for air leaks.
Check defrost evaporation pan and clean if applicable.
Check the defrost drain for blockage and leaks.
Level cabinet.
Check for proper icemaker operation.
Check ice dispenser (if applicable) for proper operation.
Check water dispenser (if applicable) for proper water flow.
Inspect electrical system.
Clean coils which is required on all new refrigerators to avoid over heating and possible explosion
DISHWASHER SERVICE
Check pump and motor shaft for leaks.
Clean pump and spray arms. Check water distribution.
Check and clean dispenser operation.
Check heating element.
Ensure correct amount of water enters the dishwasher.
Check door gasket to prevent leaks.
Level dishwasher as needed.
Inspect electrical system.
Verify proper water draining.
Inspect and clean removable filters.
Check electronics controls / buttons for proper function.
WASHER SERVICE
Check the fill cycle and water temperature for wash settings.
Ensure correct pump out and spin cycles.
Check for excessive noise and vibration during spin cycle.
Check timer for correct operation.
Inspect belt for wear and adjust tension (belt drive washers).
Check motor coupling mechanism for wear (direct drive models).
Verify clutch/shifter mechanism is functioning properly.
Check for proper spin and agitate speeds.
Check door/lid lock for proper alignment and operation.
Inspect electrical system for proper ground and secure connections.
Check tub and hoses for leaks.
Check drain pipe or laundry tub.
Inspect motor coupling for wear.
Check door boot for leaks.
Check level of machine.
Verify pedestals and/or stacking kits are properly secured.
Check fill and drain hoses for proper connection.
Check air dome for debris and pressure hose for secure fit at pressure switch.
Inspect door bellow and dispenser areas for buildup; advise on cleaning/maintenance.
DRYER SERVICE
Check front and rear drum seals.
Check the drum belt, idler pulley and support rollers for wear.
Check the exhaust system for leaks, kinks, or obstructions.
Cycle check the burner for proper ground and secure connections.
Inspect electrical systems for proper ground and secure connections.
Check thermostat temperatures and verify high heat.
Check time for correct cycle operation.
Check moisture bar operation and clean the moisture bars.
Check gas line and connections for leaks.
Check machine component functions by operating dryer through short cycle.
Check level of machine.
Vacuum the inside of the dryer.
