Dean Adams Designs

10/07/2026

$600 in just the tubing later... Now to smash it into oval bodies. Only got 8 in the pic, but there's twice that many on the shelf now. Super Cruisers and RX/SX systems getting prepped.

09/26/2026

Time to do another one then go back to the 1125 pipes, then back to this again. Love to stay busy.

09/22/2026

Some days I forget why I do what I do. This one popped up as a reminder. Been doing this for a while, but this was just 12 years ago. Seems like a blink of the eye to me anyway. Still doing the same s**t.

Short informal review of the Dean Adams Keda RT4 exhaust pipe on my...

09/19/2026

Done with this one.

09/19/2026

Should be done tomorrow. Need to take a short breather and see about hooking up the laser. We shall see if that's in the cards or not.

09/14/2026

So if you haven't heard from me in more than a month, reach out via messenger, instagram or email ([email protected]) for an update on where you're at on the list. There are a couple of guys that I built stuff for that stopped responding or I simply don't have contact info for. I still have probably 2 months worth of work on the build list. The pair in the pic below are being worked on now.

09/13/2026

Oh Canada! Yep, crossing the border again.

09/09/2026

Did this more than 10 years ago, unfortunately the Ducati snobs were not impressed since it wasn't built in Europe. 1299 duc V-twin, I think made 185-190 HP. Only made one and never finished the second one. I guess sticking with the Buell thing was a good choice.

09/07/2026

More XB and 1125 RT-4's for today.

09/04/2026

Took long enough to get here. Was supposed to be here yesterday, courier truck broke down somewhere out west of here. Finally made it to the Stl hub at 10:30 this morning, they weren't going to even attempt delivery until next week. Nope, not happening, I got a truck, will travel to get it. Just under 300 lbs. Anyway, about the machine and what it's for. Raycus 3000 watt fiber laser 4 in 1, so it cuts, cleans, removes rust and welds. All I really wanted it for was the super clean cuts on 304 stainless steel. It's probably WAY more power than I need, but it's better to go big rather than regret the purchase later when it's not enough. It will still be a while before this is operational, I need to do some wiring to connect it to my current plasma table for the conversion to the laser. Then a lot of testing to figure out speeds/feeds on it for dross free cuts. I have a fair bit of material already cut and ready to weld, so I won't be posting anything else about this for a while. This should be fun! 😀