wrk 3d

03/27/2025

I had lost my old Leatherman, and bought a new one only to find out it didn't have a pocket clip like I was used to. It comes with a soft case that attaches to your belt.

I don't wear a belt, but still wanted to carry my Leatherman around.

So, a bit of time in Fusion and few revisions later, and I had a clip that attaches to my pants and holds the Leatherman case while being strong enough for everyday use.

If you have the same issue, and access to a 3D printer, you can find the file here:

https://makerworld.com/en/models/1255650-leatherman-case-clip -1278978

I have included the .step file for this as well, so you can remix the file for your own needs.

A clip to hold your Leatherman in its case to your pants. I recommend printing with the .2 Strength profile, and using PolyMaker PolyMax PLA. The orientation in the file is the optimal orientation for part strength, so that force on the part is distributed along x/y axis and not the z axis. I dont u...

03/21/2025

I love when a custom project pushes the limits of what I am capable of.

A client reached out and wanted a customized, compact ammunition case that can be used for multiple rounds.

It took a few revisions, a lot of measuring, and learning how clearances can change when working plastic parts that will interface with metal parts to come to the final product.

An ammunition case that stacks well against each other to save space, with a snug lid that uses a brim and neodymium magnets to hold itself closed, while being able to hold up to 50 rounds. It can hold 22 ARC, 6mm ARC, 338 ARC, and 6.5 Grendel rounds.

The lid also doubles as a holding block for empty rifle casings during reloading.

02/02/2024

From a rough sketch based off of an existing part, then a prototype to test clearances, and finally a final product printed from ASA installed in a client's vehicle.

If you need any custom parts created or replicated, let us know!

01/22/2024

A new challenge arrives!

What will you be working on this week?

01/16/2024

Looking to make some sweet Valentines Day gifts?

Check out our Conversations Hearts clay cutter and text stamps! ❤️

Designed to line up the text perfectly centered every time, with plenty of fun phrases.

The cutter cuts out a heart that is 28mm(1.1 inches) across by 25mm(1 inch) tall.

If you're looking for some pre-made Conversation Heart earrings, check out Tanya has wares, if you have coin. You'll find a ton of different Conversation Hearts and more!