IV Appliance Clinic, Spokane, WA

Directions Website

IV Appliance Clinic, Spokane, WA Professional Appliance Repair Service in Spokane County, WA.

Is your washing machine leaking water from behind or struggling with slow fill cycles?We recently resolved an active wat...
11/06/2026

Is your washing machine leaking water from behind or struggling with slow fill cycles?

We recently resolved an active water leak on a Kenmore Elite front-load washer in Spokane (99223). The appliance was leaking because the cold water inlet valve assembly developed an internal seal breach, allowing water to spray onto the solenoid coil casing and accumulate rust over time. Our technician removed the top panel to access the plumbing manifold, uninstalled the corroded valve, and installed a brand-new OEM triple-solenoid cold water inlet valve assembly. After reconnecting the supply hoses and electrical terminals, full operational testing confirmed rapid water intake, precise shut-off, and completely dry, leak-free washing performance!

✅ Identified leaking cold water valve body and rusted solenoid coil housing
✅ Installed replacement OEM front-load washer water inlet valve assembly
✅ Secured distribution hoses, confirmed fast water flow, and verified zero leaks

📍 Serving Spokane, Liberty Lake, and surrounding areas.

If your washing machine is leaking water or failing to fill properly, reach out to our expert appliance repair team today for fast service!

11/05/2026

Gas oven refusing to ignite or producing no heat at all? ⚠️

Our team recently resolved a complete oven heating failure on a Samsung range in Spokane, WA (99217).

We performed an internal diagnostic inspection of the oven burner and ignition circuit. 🛠️

Diagnostics confirmed a failed igniter that prevented gas flow and stopped the oven from heating up. Fix: We removed the defective component and installed a brand-new, original OEM igniter assembly. Full ignition and even heating performance were completely restored and tested.

All repairs are backed by our standard 90-day warranty. 🛡️

Our licensed and insured technicians offer 10+ years of experience in residential appliance repair.

📞 Call now: 253-378-7549
🌐 Book online: www.iv-contractor.com/oven-repair

Is your oven turning on but leaving your food completely cold and unbaked?We recently resolved a heating failure on a GE...
11/02/2026

Is your oven turning on but leaving your food completely cold and unbaked?

We recently resolved a heating failure on a GE oven in Spokane (99207). The oven would not bake because the lower heating element suffered a severe electrical blowout, completely breaking the circuit. Our technician removed the blistered element, installed a brand-new OEM bake heating element, and tested the circuit under full load. Infrared thermal testing confirmed fast, even radiant heating, climbing smoothly to over 456°F!

✅ Inspected oven cavity and identified a burned-out, ruptured bake heating element
✅ Installed replacement OEM electric oven bake element assembly
✅ Confirmed rapid heat recovery and verified 456.6°F temperature using an infrared pyrometer

📍 Serving Spokane, Fairwood, and surrounding areas.

If your oven isn't heating or has a burnt heating element, reach out to our expert service team today for fast repair!

Is your washing machine running the drain pump non-stop and refusing to start a normal cycle?We recently resolved a cont...
10/30/2026

Is your washing machine running the drain pump non-stop and refusing to start a normal cycle?

We recently resolved a continuous draining failure on a Whirlpool top-load washer in Spokane (99217). The appliance would continuously activate the drain pump because the main electronic control board suffered an internal component short, keeping the pump circuit energized. Our technician accessed the upper console, replaced the defective board with a brand-new OEM main control board, and completed diagnostic calibration. Post-repair testing confirmed timely pump shut-off, proper water filling, and complete cycle ex*****on!

✅ Inspected console circuitry and identified a failed electronic control board
✅ Installed replacement OEM washer main electronic control board assembly
✅ Calibrated cycle parameters and confirmed proper drain pump regulation

📍 Serving Spokane, Liberty Lake, and surrounding areas.

If your washer won't stop draining or has control board issues, reach out to our expert service team today for fast repair!

Is water leaking from the front door of your washing machine, or is the rubber seal torn and moldy?We recently replaced ...
10/28/2026

Is water leaking from the front door of your washing machine, or is the rubber seal torn and moldy?

We recently replaced a damaged door boot seal on an Electrolux front-load washer in Rathdrum (83858). The original rubber bellows had worn down and deteriorated, threatening leaks during wash cycles. Our technician disassembled the front fascia, removed the old gasket and tension springs, cleaned the tub mounting rim, and installed a brand-new OEM door boot. Post-repair testing confirmed a perfect watertight fit, smooth door latching, and zero leaks during a full cycle!

✅ Inspected door seal area and identified deteriorated rubber bellows
✅ Installed replacement OEM front-load washer door boot gasket assembly
✅ Tested high-speed spin cycle to confirm watertight performance and zero leaks

📍 Serving Rathdrum, Post Falls, and surrounding areas.

If your washing machine has door gasket leaks or needs seal replacement, reach out to our expert service team today for fast repair!

Is your dryer stuck on a single cycle or is the timer k**b spinning freely without advancing?We recently resolved a time...
10/26/2026

Is your dryer stuck on a single cycle or is the timer k**b spinning freely without advancing?

We recently resolved a timer failure on a Speed Queen dryer in Spokane (99203). The appliance would not cycle through programs because internal gears inside the mechanical timer had stripped, and the selector k**b cracked. Our technician opened the rear console housing, replaced the defective unit with a brand-new OEM timer, and installed a matching control k**b. Testing confirmed positive k**b indexing, accurate timing, and full cycle completion!

✅ Inspected console wiring and identified a failed electro-mechanical timer motor
✅ Installed replacement OEM dryer timer assembly and heavy-duty selector k**b
✅ Verified accurate cycle timing, proper motor shut-off, and reliable operation

📍 Serving Spokane, Veradale WA, and surrounding areas.

If your dryer has a broken timer or won't finish cycles, reach out to our expert service team today for fast repair!

Is your front-load washing machine leaking water from around the door during wash or rinse cycles?We recently resolved a...
10/23/2026

Is your front-load washing machine leaking water from around the door during wash or rinse cycles?

We recently resolved a door seal leak on a Samsung front-load washer at a residence in Spokane (99207). The appliance was leaking because a damaged rubber door boot gasket failed to maintain a watertight seal around the glass door. Our technician disassembled the front cabinet panel, removed the worn gasket, and installed a brand-new OEM Samsung door boot seal with spring retaining clamps. Functional testing confirmed a perfect watertight fit, smooth door closure, and total leak elimination!

✅ Inspected tub seal assembly and identified a torn, worn-out rubber door boot gasket
✅ Installed replacement OEM Samsung front-load washer door gasket seal
✅ Confirmed tight seal alignment, leak-free wash performance, and complete cycle ex*****on

📍 Serving Spokane, Valleyford, and surrounding areas.

If your washer is leaking water or needs door gasket replacement, reach out to our expert service team today for fast repair!

Is your gas oven taking forever to heat up or failing to light when you start a bake cycle?We recently resolved an oven ...
10/21/2026

Is your gas oven taking forever to heat up or failing to light when you start a bake cycle?

We recently resolved an oven heating breakdown on a Samsung gas range at a home in Spokane (99217). The oven stopped heating because a worn-out bake igniter element couldn't draw enough electrical current to open the gas safety valve. Our technician removed the oven cavity panels, uninstalled the failed igniter, and installed a brand-new OEM Samsung hot-surface igniter element. Functional testing confirmed fast igniter glow, instant gas safety valve release, and steady, reliable oven heating!

✅ Inspected bake burner circuit and identified a weakened igniter element
✅ Installed replacement OEM Samsung hot-surface bake igniter assembly
✅ Confirmed fast igniter glow, immediate gas burner ignition, and proper preheating

📍 Serving Spokane, Airway Heights, and surrounding areas.

If your gas oven isn't heating or has igniter issues, reach out to our expert service team today for fast repair!

Is your side-by-side refrigerator warming up or building up thick frost on the freezer back wall?We recently resolved a ...
10/19/2026

Is your side-by-side refrigerator warming up or building up thick frost on the freezer back wall?

We recently resolved a cooling failure on a Kenmore Elite refrigerator at a residence in Deer Park. The appliance stopped cooling because a burned-out defrost heating element prevented automatic defrosting, allowing heavy frost to block airflow across the evaporator coils. Our technician defrosted the internal coils, removed the defective heater, and installed a brand-new OEM Kenmore defrost heating element beneath the assembly. Functional testing confirmed immediate heater engagement, restored airflow circulation, and fast temperature recovery!

✅ Inspected cooling system and identified a burned defrost heating element
✅ Cleared heavy evaporator coil frost buildup to restore proper air circulation
✅ Installed replacement OEM Kenmore defrost heater element

📍 Serving Deer Park, Spokane, and surrounding areas.

If your refrigerator isn't cooling properly or has defrost system issues, reach out to our expert service team today for fast repair!

Is your gas oven making a loud popping noise when lighting or taking several minutes to start baking?We recently resolve...
10/16/2026

Is your gas oven making a loud popping noise when lighting or taking several minutes to start baking?

We recently resolved a delayed ignition issue on a Kenmore Elite gas range at a home in Deer Park. The oven was experiencing delayed ignition because a degraded bake igniter element couldn't draw enough amperage to open the safety gas valve quickly, letting gas pool in the cavity before lighting with a boom. Our technician removed the bake burner tube, installed a new OEM hot-surface igniter, and secured the electrical connections. Functional testing confirmed fast igniter glow, immediate gas release, and smooth, quiet heating!

✅ Inspected oven bake burner and identified a weakened, low-draw igniter element
✅ Replaced damaged bake igniter with a new OEM hot-surface replacement part
✅ Verified rapid ignition timing, silent gas burner ignition, and proper bake heating

📍 Serving Deer Park, Spokane, and surrounding areas.

If your gas range has delayed ignition or oven heating problems, reach out to our expert service team today for fast repair!

Address

925 S Schnug Street
Spokane, WA
99224

Opening Hours

Monday 8am - 9pm
Tuesday 8am - 9pm
Wednesday 8am - 9pm
Thursday 8am - 9pm
Friday 8am - 9pm
Saturday 8am - 9pm
Sunday 8am - 9pm

Alerts

Be the first to know and let us send you an email when IV Appliance Clinic, Spokane, WA posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Nearby businesses