04/15/2026
🚨 Most GD&T training is a complete waste of time.
🫡 Yeah, we said it.
People sit through days of slides, memorize symbols, pass a quiz, and then go right back to the shop floor and still don’t know what the print actually means.
We see it constantly, experienced it, and we’ve fixed it.
😩 Parts getting rejected.
‼️Arguments between engineering and quality.
⚠️ CMM programs built on bad assumptions.
Not because people are dumb, but because the training never connected to real life. 😞
✅Klontech has built a course new & different.
A GD&T Boot Camp focused on real-world, hands-on training
No fluff. No textbook, only theory.
We use:
• real parts ✅
• real inspection scenarios on and off inspection equipment ✅
• real problems your team is already dealing with ✅
And the goal is simple:
Make GD&T actually make sense 👌
That is the standard.
📍 2-day training
🕣 8:30 AM to 4:00 PM each day
👥 Limited to 10 people
⚙️ Built for engineers, programmers, and inspectors
💡 If your team is:
• guessing on prints
• wasting time on rework
• going back and forth on interpretation
👨🔧This will fix it.
🔥 We’ve just opened up the next session:
https://klontech.com/gdt-bootcamp
Or message us if you want to run this privately for your team.
Let’s stop pretending bad training works.
https://klontech.com/gdt-bootcamp
Professional 3D scanning equipment and metrology services
