BAR-NONE MOTO

BAR-NONE MOTO Quality Custom Hand-Made Sissybars, Handlebars, Exhausts & Moto Parts Product/Service

23/10/2026

We're back to our regular work routine. Hit us up if you need anything for the road 💪🏼

13/10/2026

Floating oil tank for this Triumph T6. The front half wraps around the seat post while the rear sits in the clear with a clean looking chain relief detail & Shovelhead oil filter in the centre. Copper hard oil lines braised in with a little discreet crank case breather.

24/09/2026

Recently finished up on this little project, I did a modern hub conversion on this rare 21" star wheel. Same specs as '00-up, wheel had to be rolled to get a kink out but in the end it cam out real good. Thank you to [email protected] for the killer polishing work.

09/09/2026

BNM Dual PM calliper bracket for rigid frames.

08/09/2026

Introducing the new BNM billet FXR swing-arm. This is the prototype that I'll test over the next few month & bring to the market on a MTO basis later in the year.

08/07/2026

27/05/2026

Hardtail conversion for 's new build 💪🏼 using .supply.co axle plates

06/03/2026

NEW Product drop.
GPS motor mounts for Shovelhead & Sportster in two sizes in polished stainless steel. Panhead & Evo just around the corner!

We do not stock as they are made to order and fully customisable. You will need to purchase these directly from them via the website.

28/01/2026

Dyna Super Glide Polished Stainless Sissy Bar '95-'05 - Inside Mount for 400mm 15.5" tall with added cross bars to tie luggage down
📸 by Dean

Address

Ballarat Central, VIC
3350

Website

http://www.barnonemoto.com/

Alerts

Be the first to know and let us send you an email when BAR-NONE MOTO posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.